Programming Wireless Points In The Control Panel; Enroll Point Rf Id For Wireless Points (Auto-Learn Mode) - Bosch RFRC-OPT Reference Manual

Hide thumbs Also See for RFRC-OPT:
Table of Contents

Advertisement

RADION receiver OP
Figure 3.1: Wiring to an Option Bus Terminal Strip
Callout
1
2
3
4
3.3.4
Programming wireless points in the control panel
After completing the physical installation of the RADION system, you must configure the
RADION points in order to establish communication between the RADION system and the
supported Option bus control panel. This can be accomplished by using one of two methods:
A "point" can be a detection device, or a group of devices connected to your security system.
The first step to enable communication is to verify that the RADION transmitter is
programmed into the supporting control panel. This is achieved by configuring a point source
index as wireless, and then associating a transmitter's RFID with that point source index
RFID programming from a supported keypad is achieved by two methods;
The preferred method of entering in the RFID number would be to enter it in manually via the
keypad – point source/RFID, or remote programming software. Doing so gives you greater
control and security, while reducing the risk of incomplete RFID programming.
For more information on programming wireless points in the control panel, refer to the
Installation and Operation manual of the compatible control panel on registering the receiver.
3.3.5
Enroll point RF ID for wireless points (Auto-learn mode)
A second RFID Programming option exists whereby new devices are "Auto Learned" on the
system. Auto Learn Mode is the process through which the control panel identifies and enrolls
new device RF ID's that appear within the system. This is achieved by the following:
Bosch Security Systems, Inc.
Description
Control Panel
RADION receiver OP
Terminal Block
Terminal Wiring
Using remote programming software on a supported laptop computer, or
Compatible keypad devices to enable your points
Through the point source/RFID menu options, or
Enroll point RFID for wireless points – which uses the "Auto-Learn" methodology
Keyfobs – when the keyfob buttons are pressed, then released.
Reference Guide
RADION receiver OP | en
2014.12 | 02 | F.01U.261.835
13

Advertisement

Table of Contents
loading

Table of Contents