Lighting The Fire - Stanley Errigal Solid Fuel 47K CookerBoiler & Non Boiler Operating Instructions Manual

Before lighting the appliance:
* Check with the installer that the installation work and commissioning checks described in the
installation instructions have been carried out correctly and that the chimney has been swept
clean, is sound and free from any obstructions.
* As part of the commissioning and handover procedure the installer should demonstrate how to
operate the appliance correctly.
* Check water system is not frozen.
1. Open the Fire Door.
2. Lower Fire Fence by lifting up and then tilt forward. Fuel may also be loaded through the opening hotplate.
3. Open the Spin Valve fully by rotating it in an anit-clockwise direction. Turn the direct damper to open by
using the operating tool.
4. Kindle with paper and sticks in the usual way.
5. Ignite by using a taper or rolled wad of paper.
6. Lift up the fire fence and close the fire door.
7. Under no circumstances should any flammable liquid i.e. petrol, paraffin etc., be used to light the
fire.
8. When the fire is well established, and the flue is warm, close the direct damper fully and keep it closed.
9. Add fuel to the firebox as required and adjust the spin valve to suit the current requirements.
Note: It is also possible to access the firebox by lifting the hotplate. (See Hotplate Section).
IMPORTANT: UNDER NO CIRCUMSTANCES SHOULD ANY FLAMMABLE LIQUID, GASOLINE
KEROSENE, LIGHTER FLUID OR CHARCOAL- STARTERS BE USED TO LIGHT OR "FRESHEN UP" THE
FIRE. "KEEP ALL SUCH LIQUIDS WELL AWAY FROM STOVE (COOKER) WHILE IN USE"
THIS APPLIANCE IS HOT WHILST IN OPERATION, KEEP CHILDREN, CLOTHING AND FURNITURE A
SAFE DISTANCE AWAY.
OPERATE APPLIANCE ONLY WITH FUELLING DOOR AND ASHPIT DOOR CLOSED.

LIGHTING THE FIRE

15