Plumbing; Connection To The Water Inlet - Miele G 7883 Operating Instructions Manual

Connection to the water inlet

,
Water in the machine is not
suitable for drinking.
^ The machine must be connected to
the water supply in accordance with
local and national regulations.
^ If the iron content in the water is too
high, there is a risk or corrosion
damage to instruments.
If the chloride content in the water
exceeds 100 mg/l, the risk of
corrosion damage to instruments will
increase considerably.
^ The machine is constructed to
comply with German water
regulations (DVGW), and may be
connected to a suitable water supply
without an extra non-return valve if
national regulations allow this.
^ In the UK this machine is listed as a
WRAS approved product in the Water
Fittings and Materials Directory of
products which comply with the Wa-
ter Fittings Regulations. It is
approved for mains water connection
in fluid categories 1 to 5 inclusive,
when installed using the double
check valves supplied.
^ The water pressure (flow rate) must
be a minimum of 0.5 bar (50 kPa).
If the water pressure (flow rate) is
below 2 bar (200 kPa) the fill time is
automatically extended.
The max. permitted static pressure is
10 bar (1000 kPa).
If the water pressure is not in the
range of 0.5 to 10 bar (50-1000 kPa)
the p / 6 indicator light may come
on and the fault code "F.." show in the
display. Please contact the Miele Ser-
vice Department.
^ The machine is supplied as standard
for connection to a cold (coded blue)
and a hot (coded red) water supply
up to a max. temperature of 70 °C.
The inlet hoses should be connected
to the stopcocks for the hot and cold
water supplies.
If a hot water supply is not available,
the inlet hose marked red should also
be connected to the cold water
stopcock.
See the next page for an AD water
connection (hose marked H
^ Stopcocks with 3/4 BSP male thread
are to be provided on site. They
should be easily accessible so that
the water supply can be turned off
when the machine is not in use.
^ The DN 10 inlet hose is approx. 1.7 m
long terminating in a 3/4 inch female
thread. On no account must the inlet
filters be removed.

Plumbing

O pur).
2
51