Miele G 7883 Operating Instructions Manual page 35

1.2 DOS 3 (Neutralising agent)
1.2.1 Setting the dosage
concentration (global parameter):
Set the concentration level according to
the neutralising agent manufacturer's
recommendations.
Example: If the manufacturer
recommends a concentration level of
0.3 % set the value to 0.30.
^ Turn the programme selector to the F
position. The dosage concentration
set will appear as a % in the display:
0.05 - 0.50 = 0.05 % - 0.5 % dosage
concentration.
^ Press ß as many times as
necessary or hold it pressed in until
the required value appears.
The dosage concentration is now set.
Value set:
1.2.2 Venting the dispensing system:
a) After setting the dosage
concentration:
^ Turn the programme selector to the E
position. "do3" appears in the
display.
^ Press ß.
The dispensing system will be vented
automatically. "do3" will appear in the
display when venting is finished.
Programming special functions
Having changed a value or all values:
^ Press the 6 button. SP appears.
^ Press 6 again. The change has
been recorded.
b) If only venting is required (e.g.
because the dispensing system has
been allowed to empty by mistake)
^ Select programming level 2
(see 1.).
Then proceed as follows:
^ Turn the programme selector to the E
position. "do3" appears in the
display.
^ Press ß.
The dispensing system will be vented
automatically. "do3" will appear in the
display when venting is finished.
^ Switch the machine off with the I-0
button.
Every time the dispensing system has
been vented:
Run the PRE-RINSE programme D so
that after venting any agents in the
wash cabinet are diluted before being
drained away.
35