Installing And Using Parking Brake; Opening And Closing Your Trailer - Burley child trailer Owner's Instruction And Safety Manual

WARNING
TRAILERS CAN TIP OVER, CAUSING DAMAGE TO TRAILER AND
SERIOUS INJURY TO PASSENGERS. AVOID CAUSES OF TIP OVER,
ESPECIALLY:
• CHILDREN LEANING OR BOUNCING
• HITTING POTHOLES, CURBS, OTHER ROAD OBSTRUCTIONS
• TAKING TURNS TOO FAST
• SUDDEN SWERVING
• IMPROPER WHEEL INSTALLATION OR TIRE INFLATION

Installing and Using Parking Brake

1. Tilt trailer onto its nose and lean it against a wall.
2. Place brake assembly's center post in hole #3 in bucket
bottom. Handle grip must clear bucket. Let brake
arms hang down. Hold center post and screw it into
place.
FIGURE 1
3. Place a spring washer and fender washer on each
mounting screw. From inside of bucket, loosely thread
screw/spring washer/flat washer stack through hole and
into brake assembly center post. Do not tighten at
this point.
4. Line up brake assembly arms with outer holes #1 and #6,
and using screw/spring washer/flat washers, fasten them
from inside of bucket.
5. Using one tool on inside of bucket and one on outside,
tighten screws firmly until spring washers are fully
flattened between screw heads and flat washers. To
prevent brake return spring from distorting, use care when
tightening left screw.
6. Engage parking brake by pushing handle to the right.
Exercise caution when disengaging brake, as it may spring
to the left.

Opening and Closing Your Trailer

1. Rotate front tube upward and rear tube back until they
meet on plastic saddles.
2. Rotate frame locks and snap onto rear tube.
3. To close trailer, unclip seat buckles on back of seat and
reverse opening process.
To view a video clip of "Opening and Closing Your
Trailer" go to: www.burley.com/support/tutorials.cfm.
WARNING
CHECK THAT THE FRAME LOCKS ARE PROPERLY ENGAGED
BEFORE USING THE TRAILER. FAILURE TO DO SO CAN RESULT IN
SERIOUS INJURY.
4
B U R L E Y C U B O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
FIGURE 2
FIGURE 3
Released
1
Center
Post
FIGURE 1:
Rear underside of trailer
Rear
FIGURE 2
Frame Locks
FIGURE 3
Screws/Spri n g
Washers/Flat
Washers
Brake
2
Brake
3
Engaged
4
5
6
Front
Plastic Saddles