Installing The Cub Parking Brake - Burley d’LITE Owner's Instruction Manual

Bicycle trailer
Table of Contents

Advertisement

Installing the Cub
The trailer should be fully unfolded and the tongue removed.
1. Put the trailer on its nose on the fl oor with the roll cage leaning against
a wall or table. Sort the contents of the hardware bag.
2. Facing the underside of the bucket, locate the rear row of six molded
depressions (see illustration). Holes are drilled in the fi rst, third and
sixth depressions (numbered from the left). See illustration.
3. Put a spring washer and then a fender washer on a mounting screw.
Repeat for the other two screws.
4. Place the brass center post of the brake assembly in the number 3
depression so that the black vinyl grip on the brake handle clears the
rear of the bucket. Let the brake arms hang down. Hold the center post
and screw it into place with a Phillips screwdriver.
5. Reach inside the bucket and thread the screw/spring washer/fender
washer stack through the punched hole and into the brake assembly
center post. Don't tighten it yet.
6. Swing each of the two brake assembly arms into place in turn, so their
posts enter their respective depressions, and fasten them from the
inside of the bucket with the screw/spring washer/fender stacks.
7. Using two screwdrivers, one inside the bucket and one outside, tighten
the mounting screws fi rmly, until the spring washers are fully fl attened
between the mounting screw heads and fender washers.
8. Take care to keep the far left post
from rotating as you tighten its mounting
screw so that the brake return spring
does not distort.
Parking Brake
B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

SoloEncoreCubBeeLady bug

Table of Contents