Using Parking Brake; Installing Tow Bar; Installing Handle Bar Receivers - Burley Honey Bee Owner's Instruction And Safety Manual

Using Parking Brake

Engage parking brake by pushing handle to the right. Exercise
caution when disengaging brake, as it may spring to the
left.
PHOTO 3

Installing Tow Bar

1. Slide tow bar through both tow bar mounts on left side.
2. Match rear tow bar hole with rear mount hole.
3. Insert the retaining pin through both holes, and lock
retaining hoop securely.
WARNING
NEVER OPERATE TRAILER WITHOUT RETAINING PIN LOCKED IN
PLACE. AN UNLOCKED TOW BAR CAN LOOSEN OR DETACH,
CAUSING ACCIDENT RESULTING IN SERIOUS INJURY.

Installing Handle Bar Receivers

1. Using provided hex key wrench and handlebar screws,
install inner handlebar receiver sections on upper frame,
with narrow end of receiver sections toward trailer rear.
and
PHOTO 4 FIGURE 7
2. Match outer to inner receiver sections.
3. Insert and tighten knobs.
6
B U R L E Y H O N E Y B E E O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
FIGURE 6
Brake Handle Engaged
PHOTO 3
FIGURE 6
Trailer Rear
PHOTO 4:
Inner Receiver
Brake
Retaining Hoop
Front
Tow Bar
Rear Tow
Mount
Bar Mount
Screws
Inner Receiver
Outer Receiver
FIGURE 7
Knob