Using Parking Brake; Installing And Operating Tow Bar; Installing Cover; Attaching Handle - Burley d’lite Owner's Instruction And Safety Manual

Using Parking Brake

Engage parking brake by pushing handle, at bottom rear of
trailer, to the right. Photo 4 Disengage by moving parking brake to
the left.

Installing and Operating Tow Bar

1. Slide tow bar through both tow bar mounts on the LEFT side.
2. Line up BACK tow bar hole with rear tow bar mount hole.
3. Insert retaining pin through rear holes, and close spring clip
securely. Figure 6
WARNING
NEvER OPERATE TRAILER WITHOUT RETAININg PIN LOCkED IN PLACE. AN UNLOCkED TOW
BAR CAN LOOSEN OR DETACH, CAUSINg ACCIDENT RESULTINg IN SERIOUS INjURY.
|

B U R L E Y C H I L D T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L

Installing Cover

Slip D-rings over hooked corners of front tow bar mounts and
attach buckle sections below side windows. To stow front
window, unzip, roll up and insert loop fastener ends on elastic
straps into hook fastener holders. Adjust sunshade as needed.

Attaching Handle

Slide handle into lower handle bar
receivers and tighten knobs.
To change height position, flip
handle over. Photo 5
Photo 4

Installing Safety Flag

Tiger d'lite:
Slip lower end of pole through
opening in Tiger d'lite tail seam
and out through the tail bottom.
All:
Insert flag pole into hole in top of
handle bar receiver. Photo 6
IMPORTANT:
DO NOT USE TRAILER WITHOUT SAFETY FLAg.
LEFT