Using The Walk 'N Roller Wheel; Installing The Brake - Burley Pre-2004 d’Lite User Manual

Bolt must go through hole in fl exible coupling. Otherwise,
hitch could come loose causing an accident resulting in
injury or death.
VI. Using the Walk n' Roller Wheel
The wheel has two positions. One is for use as a trailer, "bike" position. The other is for
use as a stroller, "stroll" position. Before changing engage the parking brake.
To rotate the wheel, loosen the knob, #1.
This will loosen the triangular pivot clamp, #2, enough to rotate. Then rotate to either
the "bike" or "stroll" position as needed. Then tighten the knob.
Do not attempt to hitch the trailer to the bike with the wheel in "stroll" position.
VII. Installing the Brake
Note: If you have a 2004 Encore, this step is unnecessary.
Parts Needed for Brake Installation:
(1) brake assembly
Locate the gap in the trailer fabric that is behind the right wheel. The gap exposes a
1 inch diameter, aluminum main frame tube that runs along the inside of the wheel.
Undo the clamp in the brake assembly by removing the 1.5 inch long hex head bolt.
2
1
(1) ¼" x 1.5" hex head bolt (1) ¼" nut
Burley Walk 'n Roller Manual; models 2003 and earlier
9