Installing Tow Bar; Installing Handle Bar And Roll Bar - Burley child trailer Owner's Instruction And Safety Manual

Installing Tow Bar

1. Slide tow bar through both tow bar mounts on LEFT
side.
FIGURE 4
2. Match rear tow bar hole with rear mount hole.
3. Slide tow bar lock pin through rear holes and rotate pin
toward rear.
4. Insert retaining pin through front tow bar holes, and lock
hoop securely.
WARNING
NEVER OPERATE TRAILER WITHOUT RETAINING PIN LOCKED IN
PLACE. AN UNLOCKED TOW BAR CAN LOOSEN OR DETACH,
CAUSING AN ACCIDENT RESULTING IN SERIOUS INJURY.

Installing Handle Bar and Roll Bar

1. Install inner handle bar receivers and roll bar with narrow
end of receiver toward trailer rear and curved roll bar front
extending above trailer body.
2. Using provided hex key wrench, secure with screws and
lock nuts as shown.
3. Match outer to inner receiver sections and insert knobs.
4. From rear, slide handle bar into lower handle bar receivers
and tighten knobs securely. To change height position, flip
handle bar over.
PHOTO 4
6
B U R L E Y C U B O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
and
PHOTO 3 FIGURE 5
FIGURE 4:
Side view of trailer
PHOTO 3:
Inner Receiver
Screws
Inner Handle
Bar Receiver
Roll Bar
FIGURE 5:
Roll bar installtion
Handle Bar
Tighten Knob
PHOTO 4:
Tighten knob clockwise
Front Tow Bar Hole
Rear Tow Bar Mount
Retaining Pin
Trailer Rear
Rear Assembly
Lock Nuts
Frame
Outer Handle
Bar Receiver
Lock
Pin
Handle Bar
Knob