Names And Functions Of Indications On Remote Control - Toshiba RAS-M10UKV-E3 Service Manual

8-5-2. Names and functions of indications on remote control

Display
All indications, except for clock time indication, are indicated by pressing the START/STOP button.
1 1
1 1 Transmission mark 1
This transmission mark (,) indicates when the remote control transmits signals to the indoor unit.
2 2 2 Mode display
2 2
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Dry, : Heat,
3 3 Temperature display 3
3 3
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
setting is indicated.
4 4
4 4 4 Louver operation display
Indicates the louver positioning and operation.
Five selectable positions
5 5 FAN speed display 5
5 5
Indicates the selected fan speed. AUTO or one of five fan speed levels
(LOW , LOW +
can be indicated.
Indicates AUTO when the operating mode is either AUTO or
6 6 6 TIMER and clock time display 6 6
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER operation.
7 7 7 7 7 Hi POWER display
Indicates when the Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop
the operation.
8 8 8 8 8
(MEMORY) display
Flashes for 4 seconds when the MEMO button is pressed during
operation.
mark is indicated when keeping the button depressed for more
than 4 seconds while the mark is flashing.
Press another button to turn off the mark.
9 9 9 ECO TIMER display 9 9
Indicates when the ECO TIMER is in operation.
Each time you press the ECO button, the display changes in the sequence of 1,3,5 or 9h.
: Fan only)
: Fan only, no temperature
Automatic
, , , ,
+
, MED , MED
: Cool,
Swing
, HIGH )
: Dry.
– 63 –
3 1 2 8
AUTOA
A
B
9 7 5
• In the illustration, all indications
are indicated for explanation.
During operation, only the
relevant indications will be
indicated on the remote control.
A
A
B
4
6