Names And Functions Of Indications On Wireless Remote Controller; Preparation And Check Before Use - Toshiba MMK-UP0301HP-UL Owner's Manual

Names and functions of
indications on wireless remote
controller
Display
All indications, except for clock time indication, are
indicated by pressing the START/STOP
button.
• In the illustration, all indications are indicated for
explanation.
During operation, only the relevant indications
will be indicated on the remote controller.
Transmission mark
This transmission mark (
remote controller transmits signals to the indoor unit.
Mode display
Indicates the current operation mode.
(A : Auto : Cool,
Temperature display
Indicates the temperature setting (62°F to 8 6°F)
(17°C to 30°C).
When you set the operating mode to
: Fan only, no temperature setting is indicated.
FAN speed display
Indicates the selected fan speed. AUTO or one of ve
fan speed levels (LOW
MED + , HIGH
Indicates
TIMER and clock time display
The time set for timer operation or clock time is
indicated.
The present time is always indicated except for
TIMER operation.
Hi POWER display
Indicates when the high power operation starts.
Press the Hi POWER button to start and press it
again to stop the operation.
(PRESET) display
Indicated when memorizing the preferred operation
mode or when it has been memorized.
Also, this icon is indicated when the memorized
preferred operation is displayed.
13-EN
Carrier 1130850202.indb 13 Carrier 1130850202.indb 13
) indicates when the
: Dry, : Heat, : Fan only)
, LOW + , MED
) can be indicated.
when the operating mode is
(COMFORT SLEEP) display
Indicated during the OFF timer operation that
automatically adjusts the room temperature and
the fan speed. Each time you press the COMFORT
SLEEP button, the display changes in the sequence
of 1h, 3h, 5h, and 9h.
(QUIET) display
Indicated during the quiet operation.
Swing display
Indicated during the swinging operation where the
horizontal louver automatically moves up and down.
NOTE
When both wired remote controller and wireless
remote controller are used, display on the screen
of wireless remote controller may differ from the
actual operation in some cases.

Preparation and check before use

1. Loading Batteries
• Remove the battery
cover.
• Insert 2 new batteries
(R03 [AAA]) following
the (+) and (-)
positions.
2. Removing Batteries
• Remove the battery
cover.
• Remove the 2 used
batteries.
Batteries
• To replace the batteries, use two new batteries
,
(R03 [AAA]).
• In normal use, the batteries will last about one
: Dry.
year.
• Replace the batteries if there is no receiving
beep from the indoor unit or when the air
conditioner cannot be operated using the remote
controller.
• To avoid malfunctions by battery leakage,
remove the batteries when not using the remote
controller for more than one month.
• Please dispose of the used batteries according to
the local regulation.
– 13 –
Owner's Manual
9/26/22 12:02 PM 9/26/22 12:02 PM