How To Replace The Main Parts - Toshiba RAS-M10UKV-E3 Service Manual

11-1. Indoor Unit
No. Part name
1
Front panel
2
Electrical part
3
Horizontal
louver

11. HOW TO REPLACE THE MAIN PARTS

Procedures
How to remove the front panel
1) Stop operation of the air conditioner and
turn off its main power supply.
2) Pull the air inlet grille toward you to open it
and remove the air inlet grille.
Then remove the 4 screws fixing the front
panel.
3) First open the horizontal louver, and then
remove the front panel from the back body
by pulling it toward you.
How to mount the front panel
Push the front panel back in and make
sure all hooks are locked.
How to remove the electrical part.
1) Remove the front panel with procedure 1.
2) Remove the screw holding the electrical
part cover.
3) Remove the drain guide.
4) Disconnect the 2 connectors (3P) for the
fan motor and the connector (5P) for the
louver motor from the P.C. board assembly.
5) Pull out the TC sensor from the sensor
holder.
6) Remove the screw for the ground
connection, remove the screw for the
electrical part box and remove the screw
from the LED unit. Then remove the LED
unit and the electrical part box from the
main unit.
How to mount the electrical part.
1) To put back the electrical part box, lock it
to the upper hook of the back body.
2) Tighten the screw on the electrical part
box.
3) Connect the 3 connectors and arrange the
wiring same as original condition and then
tighten the screw from the LED unit to the
back body.
4) Attach the TC sensor to the holder.
5) Tighten the screw for the ground connection.
6) Assemble the drain guide (the TC sensor
wire should be covered by the drain guide).
7) Tighten the screw on the electrical part cover.
1) Remove the front panel and the electrical
part following procedure 2.
2) Remove the center shaft of the horizontal
louver from the back body.
3) Remove the left shaft from the back body.
4) Remove the horizontal louver from the
back body.
– 100 –
Remarks
2
2
2 4-Screws
3
2 Screws
3 Drain guide
5 TC Sensor
6 Screws
3-Connectors
6
Screws
2 Center shaft
3 Left shaft
2
4