Operating Clips/Still Images With A Computer - Sony PMW-10MD Operating Instructions Manual

Operating Clips/Still
Images with a Computer
The clips recorded on SxS memory cards with
this unit can be controlled on a computer or edited
using the optional nonlinear editing software.
For these purposes, the clips/still images on an
SxS memory card can be operated by directly
loading the card in a unit or by connecting the unit
or an SxS memory card USB reader/writer to the
computer, using a USB cable as shown below.
Preparations
To use the ExpressCard slot of a computer
If the computer is equipped with an ExpressCard/
34 or ExpressCard/54 slot, you can directly insert
the SxS memory card containing clips/still
images recorded with this unit and access to the
files.
For the operating requirements for the computer, see
"Using the CD-ROM" on page 15.
Note
The SxS Device Driver Software on the CD-
ROM labeled "Utility Software for Solid-State
Memory Camcorder and Recorder" must be
installed on your computer. Before installation,
be sure to read the enclosed SxS Device Driver
Software End-User License Agreement.
For information on installation of the driver, refer to
the ReadMe on the supplied CD-ROM.
For support information for the driver, visit the
following URL:
http://www.sony.net/SxS-Support/
to the
ExpressCard
slot
SxS memory card
With a Windows computer, check that a
Removable Disk appears in My Computer. This
indicates normal status.
With a Macintosh computer, an icon is displayed
on the menu bar.
Computer with SxS
Device Driver Software
installed
To use with an SxS memory card USB reader/
writer
When you connect an SxS memory card USB
reader/writer using a USB cable, the memory card
in the slot is acknowledged as an extended drive
by the computer.
SxS memory card
USB cable
Computer with SxS
Device Driver Software
installed
Note
When connecting the USB cable to the computer,
be careful to check the form and direction of the
USB connector.
To check the connection
With Windows, check that the memory card is
displayed as a removable disk in My Computer.
With Macintosh, check that a "NO NAME" or
"Untitled" folder was created on the desktop.
This indicates that the connection is active. (The
folder name on the desktop of the Macintosh
computer can be changed as needed.)
Note
The following operations must be eliminated
when the access lamp is lit to show writing is in
execution.
• Turning the power off or disconnecting the
power cord
• Removing the SxS memory card
• Disconnecting the USB cable
When using an SxS memory card USB reader/writer,
refer to the operating instructions for it.

Operating Clips/Still Images with a Computer

SxS memory card
USB reader/writer
57