Setting The Clock - Sony PMW-10MD Operating Instructions Manual

Setting the Clock

When you turn the unit on for the first time after
purchasing or replacing the backup battery (page
70), the initial setting display appears in the
monitor screen connected to this unit.
Set the date and time of the built-in clock, using
this display.
Time Zone
The value shows the time difference from UTC
(Coordinated Universal Time).
Change the setting if needed.
Setting the time and date
To set the date and time, use the SEL/SET knob
in the menu/media operation section inside cover
of the front panel of the CCU.
1
Turn the SEL/SET knob to set the
cursor to "Date/Time" then press the
knob.
The cursor moves to the year-setting column.
SEL/SET knob
CANCEL button
2
Turn the SEL/SET knob to set the year
then press the knob.
The cursor moves to the month-setting
column.
3
Set the month, day, hour, minute, and
second in sequence in the same manner.
When you press the SEL/SET knob at
"SET," the cursor moves back to "Date/
Time."
To change a numeric value after entering
it
Press the CANCEL button.
The value disappears, and you can enter it
again.
4
Move the cursor to "Finish" then press
the SEL/SET knob.
The initial setting display disappears, and the
clock setting is completed.
Once after the initial setting display disappears,
the time zone and date/time settings can be
changed using "Time Zone" (page 66) and
"Clock Set" (page 67) of the OTHERS menu.
Notes
• If the clock setting is cleared because of
exhaustion of the backup battery while no
operation power was being supplied, the initial
setting display will be displayed when you turn
the unit on at the next opportunity.
• While the initial setting display is shown, no
other operation except turning the power off is
permitted until you finish the setting for this
display.
23
Setting the Clock