Removing A Board; Installing An Additional Serial Port - Fujitsu Siemens Computers PRIMERGY ECONEL 10 Operating Manual

Installing an additional serial port

Removing a board

Ê
Open the system unit (see
Ê
Disconnect the cables connected to the board.
1
2
Ê
Remove the screw (1).
Ê
Remove the board from the system unit (2).
Ê
Place the board into appropriate packaging.
To ensure proper cooling, fire protection and observation of the relevant EMC
!
(electromagnetic compatibility) regulations, you must mount a rear slot cover plate.
Ê
Push the rear slot cover plate into the slot (3).
Ê
Fasten the rear slot cover plate with the screw (4).
Ê
Close the system unit (see
If you have installed or removed a PCI board, please check the relevant PCI slot settings
i
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
Installing an additional serial port
An additional serial interface can be installed in a rear slot cover plate like a board. The condition is
that the system board has a free internal serial port.
Ê
Connect the cable of the additional serial port to the connector on the system board.
A26361-K831-Z100-1-7619
"Opening the system
"Assembling the system
unit").
3
4
unit").
System expansions
35