Troubleshooting And; The Screen Stays Blank - Fujitsu Siemens Computers PRIMERGY ECONEL 10 Operating Manual

Troubleshooting and tips Power-on indicator remains unlit after you have switched on your d

The screen stays blank

If your screen remains blank this may be due to the following:
Monitor is switched off
Ê
Switch your monitor on.
Power saving has been activated (screen is blank)
Ê
Press any key on the keyboard.
or
Ê
Deactivate the screen saver. Enter the appropriate password.
Brightness control is set too dark
Ê
Adjust the brightness control. For detailed information, please refer to the Operating Manual
supplied with your monitor.
Power cable not connected
Ê
Switch off the monitor and the PC.
Ê
Check that the power cable of the monitor is properly connected to the monitor and, depending
on the connector, to the system unit or to the grounded power outlet.
Ê
Check that the power cable of the PC is plugged properly into the system unit and grounded
power outlet.
Ê
Switch on the monitor and the system unit.
Monitor cable not connected
Ê
Switch off the monitor and the system unit.
Ê
Check that the monitor cable is properly connected to the system unit and monitor.
Ê
Switch on the monitor and the system unit.
Wrong monitor has been set under Windows NT
Ê
Restart the PC in standard VGA mode.
Ê
Set the desired resolution under Start - Settings - Control Panel - Display , and adjust the monitor
display as described in the Operating Manual of the monitor.
Wrong monitor has been set under Windows 9x
Ê
Restart the PC.
Ê If the message Starting Windows 9x appears, press function key [F8]
The Windows 9x Start menu appears.
Ê
Select the option Safe mode or Safe mode with network support .
Ê
Set the desired resolution under Start - Settings - Control Panel - Display , and adjust the monitor
display as described in the Operating Manual of the monitor.
26
[F8].
[F8] [F8]
A26361-K831-Z100-1-7619