Table of Contents
Advertisement
TO RECEIVE A CALL
NOTE: If you are expecting incoming calls, the handset must be programmed to RING ON mode.
A. IF THE HANDSET IS ON THE BASE UNIT
1. When the phone rings, simply pick up the handset from the base cradle if the unit is set
to auto-answer ON mode. If the unit is set to auto-answer OFF mode, press the TALK
button. See page 13 to set auto-answer mode. The LCD Display will show "TALK".
2. Start your conversation.
3. To end your conversation, either press the TALK button or place the handset on the base
unit. The handset LED indicator will turn off
B. IF THE HANDSET IS OUT OF THE BASE UNIT
1. When the phone rings, press the TALK button on the handset. The LCD Display will show
"TALK" and the handset and base unit LED will light up.
2. Start your conversation.
3. To end your conversation, either press the TALK button or place the handset on the base
unit. The handset LED indicator will turn off.
LAST NUMBER REDIAL
A. AFTER HEARING A BUSY TONE WHEN PLACING A CALL
1. If you get a busy tone, press handset TALK button to hang up.
2. Press the handset TALK button again and listen for a dial tone.
3. Press the handset REDIAL button. This will automatically redial the last telephone
number you called (Up to 32 digits).
4. When finished with your call, press the TALK button or place the handset on the base
unit. The handset LED indicator will turn off.
B. WHEN THE HANDSET IS OFF THE BASE UNIT AND IN STANDBY MODE
1. Press the TALK button on the handset and listen for a dial tone.
2. Press the REDIAL button. This will automatically redial the last telephone number you
called (Up to 32 digits).
3. When finished with your call, press the TALK button or place the handset on the base
unit. The handset LED indicator will turn off.
PAGING FROM BASE TO HANDSET
1. Press the PAGE button on base.
2. All handset beeps and shows "PAGING FROM BASE". The page signal will last for 2 minutes.
PAGING AND INTERCOM WITH OTHER HANDSET
1. Press INT button on handset.
2. Press digit key 1~4 to input destination handset number.
3. Destination handset beeps, the page signal will last for 2 minutes.
4. If user presses the INT button on destination handset, it will bring both handsets into
INTERCOM mode.
5. When finish with the intercom, press INT button on handset will end the intercom mode.
RING ON INTERCOM
1. During intercom mode, if there comes an incoming call, caller ID will display on the screen.
2. Short beep alert will be heard.
3. Any user can press TALK key to end the intercom and take the call.
4. If the handset is replaced to cradle, the intercom will be ended and the handset starts ringing.
QUICK TRANSFER CALL TO OTHER HANDSET
1. During a call, the user can press the INT key followed by destination handset number (1~4).
2. Press TALK key to end and the call is quick transferred to the destination handset, it starts
ringing and shows "TRANSFER FROM HANDSET 1".
3. If destination handset user does not answer the call within 30 sec, source handset will be
ring back for 30 sec.
14
Advertisement
Table of Contents
