Transfer Call After Intercom; Conference With Line; Saving In The Phonebook; Telephone Keypad Characters - Bell Excursion 35850 Instructions Manual

TRANSFER CALL AFTER INTERCOM

1. During a call, the user can press the INT key followed by destination handset number (1~4).
2. If destination handset user presses the INT key to answer the intercom request, intercom
mode is setup and call is on hold.
3. After the intercom, source handset can press TALK button to end the intercom and the call
is taken by the destination handset automatically.

CONFERENCE WITH LINE

1. During a call, the user can press the INT key followed by destination handset number (1~4).
2. If destination handset user presses the INT key to answer the intercom request, intercom
mode is setup and call is on hold.
3. In intercom mode, source handset user can press CONF button to get the destination
handset into the conference mode with the external line. After conference, any handset
can quit the conference by pressing TALK button.

SAVING IN THE PHONEBOOK

1. Press the MEM button.
2. Press UP/DOWN button to select location, or enter 2 numeric digits to select location
directly. (01~20)
3. Press MENU to confirm editing in the current location.
4. Use the TELEPHONE KEYPAD buttons (0-9) to enter the name. You can store up to 15
characters.
5. Press MENU button once.
6. Enter the telephone number using the TELEPHONE KEYPAD buttons (0-9). You can
store up to 24 digits.
7. Press MENU button to save into current memory location and goes back to Standby mode.
NOTE: The above procedure will overwrite current location if it is not empty. If no active buttons
are pressed for 60 seconds, the LCD Display will automatically return to STANDBY mode.

TELEPHONE KEYPAD CHARACTERS

The TELEPHONE KEYPAD buttons (0~9) are used to enter the characters when entering
names. Press the appropriate KEYPAD button to get the following characters.
Keypad Button
Example: If you want to enter the character "C", press the "2" KEYPAD button, the first
character displayed will be "A". Press the "2" button again within 1 second to display "B", and
press again within 1 second to display the letter "C". To enter the next character, press the
appropriate button. If, however, the next character is on the same button as the previous
character, you will need to wait for 1 second until the cursor shifts. If you want to change any
character, you can go backward by pressing DELETE button to erase character one by one.
15
Multi-tap Characters
1
2
3
4
5
6
7
8
9
Spc _ * !
A B C (
D E F )
G H I $
J K L /
M N O ;
P Q R S
T U V ?
W X Y Z
05111A-1