Table of Contents
Advertisement
Removing the Pentium II with SECC2 Package Type Fan-sink
1.
Use a screw driver to slide the fastener odes outward to unlock the fan-sink.
2.
Carefully remove the fan-sink from the processor.
Installing the Pentium II with SECC2 Package Type Processor into the System
Board
Follow these steps to install the processor module:
1.
Unfold and pull out the sides of retention mechanism.
2.
Place the retention mechanism over the CPU connector on the system board and press it until it clicks into
place.
3.
Press down the four plastic rivets to secure the retention mechanism. Make sure all four rivets are
properly inserted into the holes on the system board.
40
Chapter 3
Advertisement
Table of Contents
