Installing A Processor Card (Pentium Ii); Installing The Retention Mechanism - Acer Power 6100 User Manual

4.5.2

Installing a Processor Card (Pentium II)

Observe the ESD precautions when installing or
removing a system component. See section 4.1.1
Before you proceed, make sure that there is no processor installed in the CPU connector.
Follow these steps to install a processor card:
1. If the retention mechanism has never been installed, place the retention mechanism over the CPU connector
on the system board and press it until it clicks into place.
2. Press the four rivets to secure the retention mechanism. Make sure all four rivets are properly inserted into the
holes on the system board.
Figure 4-11 Installing the Retention Mechanism
3. Remove the processor card from its protective packaging. Make sure that the latches on the sides of the
module are not pressed in.
4. Remove the thermal tape protector at the back of the fan sink.
Index
cix