Assembly; Attaching The Debris Collection Bag; Loose Parts In Carton - Craftsman 247.776360 Operator's Manual

IMPORTANT: This unit is shipped without gasoline or
oil in the engine. After assembly, see OPERATION sec-
tion of this manual for proper fuel and engine oil fill-up.
This Chipper Shredder has been completely assembled
at the factory, except for the debris collection bag,
which is stowed in the chipper chute for shipping.
Removing Unit From Carton
1. Remove staples, break glue on top flaps or cut tape
at carton end and peel along top flap to open carton.
2. Remove any loose parts.
3. Cut down along carton edges and lay carton down
flat.
4. Remove packing material, if present. Lift unit from
the rear and discard bottom pad, if present. Roll unit
out of carton. Check carton thoroughly for loose
parts.

Loose Parts In Carton

a. One Debris Collection Bag
b. One Pair of Safety Glasses
c. One 20 oz. Bottle of Engine Oil
d. One Operator's Manual

ASSEMBLY

2. To attach the bag:
a. Place the opening of the bag completely over the
chute deflector.
b. Position the bag so that the wing knobs which
secure the chute deflector to the impeller housing
are completely covered.
c. Pull on the drawstrap until the bag is tight around
chute deflector opening. See Figure 1.

Attaching The Debris
Collection Bag
Figure 1