Español - Craftsman 247.776360 Operator's Manual

Sears Craftsman . HP Chipper Shredder Model .0
Do NOT place branches over 1/2 inch
d i a m e t e r i n t o t h e l a r g e Shredder
Hopper. Branches over 1/2 inch in
diameter should be placed in the
Small Chipper Chute.
Material feed into hopper
should be metered as
1/2"
instructed in operator's
manual to avoid clogging.
2" Chipping Capacity 2" Chipping Capacity
• Read the operator's manual(s) before starting and using unit.
• Keep all shields and guards in place and securely attached.
• Keep hands, feet, face, clothing and long hair out of Shredder
Hopper, Chipper Chute and Discharge Chute while the engine is
running. Rotating cutting blades inside these openings will cause
serious personal injury if contacted. Material being processed
may bounce back from inlet openings or be thrown from the
discharge chute. Long hair or loose clothing may be pulled
or sucked into the inlet openings.
• If the chipper shredder jams or becomes clogged, refer to
operator's manual on clearing a blockage.
777D10398
PARTS LIST
777S32604
DANGER
• If engine stalls because of jam, move throttle control lever to
stop position or shut-off rocker switch to "O" OFF if equipped,
before clearing.
• Do not install remove, adjust, or service the discharge screen or
any other part while the engine is running. Blade contact can
occur.
• Do not operate on uneven ground where unit is unstable.
• Do not operate with Chipper Chute in up position if equipped.
Latched up is for storage only. Unlatch, lower and lock Chipper
Chute in place before operating machine.
• Do not operate on pavement, gravel or other hard surfaces
since objects can ricochet and cause injury.
R R
1
• To avoid a fire hazard, keep leaves, grass, and other
combustible materials away from hot engine and muffler.
• Keep children and others away from area of operation.
• Wear approved safety glasses, gloves and ear protection.
777S32282
DO NOT OPERATE THIS MACHINE
UNLESS THE CHUTE DEFLECTOR
HAS BEEN PROPERLY INSTALLED.
777S30180