Changing The Storage Server; Setting The Master Storage Server - Canon K-64 User Manual

Changing the Storage Server

In order to retrieve information, you must be connected to a
Master Storage Server, even if it is on the same computer as the
Note
Viewer.
After installation, the Master Storage Server is set to 'localhost'.
This indicates that the Viewer will attempt to use the local
computer as its Master Storage Server.
After installation, the default user 'admin' with the password 'NVR'
is setup. It is strongly recommended that this is changed after
Tip
installation.

Setting the Master Storage Server

If you installed the Viewer and Storage Server on separate PCs, be sure to configure a
Master Storage Server in the first place. By default, the Master Storage Server is set to
'localhost'.
If you are unsure of the address to use, see your System Administrator.
Enter a Storage Server address and Port number
If you clicked the Cancel button
during launch, the Connect to
Master Storage Server dialog will
appear.
A different Master Storage Server
can be selected by overwriting the
existing Host Name or IP address
and Port number with another.
Enter a Host Name or IP
1
address for a new Master
Storage Server, then enter the
Port number.
Click Connect to continue.
2
3
31