Setting Up The Camera Servers; About The Master Storage Server; When Using Multiple Storage Servers - Canon K-64 User Manual

Before you begin Installation...

Setting up the Camera Servers

First make sure the firmware is the required version or later (as specified in the
1
table P. 12).
Check to ensure the Camera Server has been correctly installed and that the initial
2
settings (network settings) have been made. Then connect to the network.
For procedures on installing and setting up Camera Servers and cameras, please see
the manuals supplied with the Camera Servers and cameras.

About the Master Storage Server

A Master Storage Server is the Storage Server which a Viewer will connect to in the first
place. Information about Camera Servers, Locations and Zones and Viewer Layouts are
stored on the Master Storage Server.

When using multiple Storage Servers...

If multiple Storage Servers are being used, you should decide which one is the Master
Storage Server.
A typical multiple Storage Server arrangement could be:
Master Storage Server
Note
18
Play Video to Viewer
Load Camera Server information
Load Zones and Locations
Load Viewer Layouts
Save Camera Server information
Save Zones and Locations
Save Viewer Layouts
It is recommended that all Viewers within a system use the
same Storage Server as a Master Storage Server. This ensures
that all Viewers use the same Zones, Locations and Viewer
Layouts.
For correct operation, the time setting of all PCs within a
system (including Storage Servers and Viewers) must be
correct.
Viewer
Storage Server #2
Storage Server #3