Sata Or Sas Hard Drive Option - HP ProLiant ML350 User Manual

NOTE:

SATA or SAS hard drive option

IMPORTANT:
part of the x3/x1 cable be linked to the SAS hard drive backplane connector that corresponds
to hard drive slots 1 to 4. In this setup, hard drive slot 1 will not be available, but since hard
drive slots 2 to 4 will be connected, one continuous volume can be created. All drive slots will
be available in LFF systems.
To install the component:
Open the bezel (tower model)
1.
Remove the existing hard drive blank (on page 38).
2.
NOTE:
Depending on model purchased, the server may look slightly different than shown.
When installing a x3/x1 SAS cable in a SFF system, HP recommends that the x3
("Open or remove the tower
Depending on model purchased, the server may look slightly different than shown.
bezel" on page 18).
Hardware options installation 39