Powering Up And Configuring The Server - HP ProLiant ML350 User Manual

WARNING:
equipment:
• Observe local occupational health and safety requirements and guidelines for manual
material handling.
Get help to lift and stabilize the product during installation or removal, especially when the
•
product is not fastened to the rails. When the server weighs more than 22.5 kg (50 lb), at
least two people must lift the server into the rack together. A third person may be required
to help align the server if the server is installed higher than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable
when not fastened to the rails.
CAUTION:
rack. Install the heaviest item first, and continue to populate the rack from the bottom to the top.
Install the server and cable management arm into the rack. Refer to the installation instructions that
1.
ship with the 3-7U Quick Deploy Rail System.
Install an additional extender bracket (included with the server) to the cable management arm. Refer
2.
to "Converting the cable management arm swing" in the installation instructions that ship with the 3-
7U Quick Deploy Rail System.
Connect peripheral devices to the server
3.
Connect the power cord to the rear of the server.
4.
Connect the power cord to the AC power source.
5.

Powering up and configuring the server

To power up the server, press the Power On/Standby button.
While the server boots, RBSU and the ORCA utility are automatically configured to prepare the server for
operating system installation.
To configure these utilities manually:
This server is very heavy. To reduce the risk of personal injury or damage to the
Always plan the rack installation so that the heaviest item is on the bottom of the
("Rear panel components" on page 9).
Setup 27