Install the DIMM.
6.
Do one of the following:
7.
Install the right DIMM baffle.
o
Install the left DIMM baffle.
o
Install the access panel (on page 16).
8.
Install the server blade
9.
Power up the server blade (on page 14).
10.
Hot-plug SAS or SATA hard drive option
IMPORTANT:
IMPORTANT:
•
Installation of both SAS and SATA hard drives in a single RAID volume
Installation of SSD and rotating media hard drives in a single RAID volume
•
A Smart Array P410i controller supports either two hot-plug SAS or two hot-plug SATA hard drives. Hard
drive activity is indicated by the hard drive LEDs on the hard drives.
RAID 0 and 1 are supported and do not require a cache module to be installed.
CAUTION:
or the enclosure unless all hard drive and device bays are populated with either a component or
a blank.
To install the component:
("Installing a server
To avoid improper operation, install only hot-plug hard drives in this server blade.
The following configurations are not supported:
To prevent improper cooling and thermal damage, do not operate the server blade
blade" on page 28).
Hardware options installation 47