Table of Contents
Advertisement
-
2.7 Setting DIP Switches
In order to suit user's specific requirement, desired control modes are selectable via
two built-in DIP switches. These DIP switches are located inside the printer.
To obtain access to the DIP switches, follow the steps listed below.
CAUTION:
The electronic components in the printer can be damaged by static electricity
discharges. To avoid damage, make sure you discharge any static electricity from
your hands and avoid touching components on the circuit boards other than the DIP
switches.
1.
Unplug the power cord.
-
2. Remove the screws on SW Access Cover with a Phillips-type screwdriver.
3. Pull the cover in the direction of the arrow with both hands as shown below.
-
-
Removal of the SW Access Cover
-
-
2-7
Advertisement
Table of Contents
