Timers; Access Options; Secret Codes; Window Times - Regency 4720 Installation Manual

Regency ® Model 4720 Control/Communicator Installation Manual (P/N 150476, Rev. A)

Timers:

17.1.5
Aud Shutdown = 9 (9 × 10 = 90 seconds);
Exit Delay = 30 seconds;
Entry Delay 1 = 30 seconds;
Entry Delay 2 = 60 seconds;
Swinger Window = 4 hours;
RF Supervision = 24 hours;
Door Strike = 6 (6 × 0.8 = 5 seconds);
Door Open Max = 60 seconds;
Alm Rep Delay = 15 seconds;
Special Days = Saturday and Sunday.

Access Options:

17.1.6
All functions (DR, BY, CL, OP) enabled for all codes (0-99).

Secret Codes:

17.1.7
Duress Trigger = 99;
Code 0 = 123456.

Window Times:

17.1.8
Norm Open = from 06:30 until 09:30;
Norm Close = from 16:00 until 20:30;
Spec Open = from Never until Never;
Spec Close = from 00:00 until 00:00 (always)

System Messages:

17.1.9
(The preprogrammed system messages are listed in the Model 4720 Programming Record, P/N
150298.)

Zone Types:

17.1.10
Zone 1 = Fire, No Shutdown;
Zones 2-80 = Intrusion;
Zone 81 (FIRE key) = Fire;
Zone 82 (AUX key) = Panic;
Zone 83 (POLICE key) = Panic.

Reprogramming the EEPROM

17.2
To change the options, the EEPROM must be reprogrammed using the Model 5520 Programmer, the Model
5540 Downloading Software or one of the touchpads that has an LCD. For more information on
programming, see Section 18, the Programming Options Description (P/N 150299) and the Model 4720
Programming Record (P/N 150298).
Note: Use of a touchpad for system programming is not recommended due to extensive programming
options. However, reprogramming (changing) of selected options can be easily accomplished by
using the Hex Programming Manual which is available from ITI (P/N 150601).
When reprogramming the EEPROM, you must load the
preprogrammed information into the programmer BEFORE
editing. If this is not done, valuable default information will be
lost.
CAUTION:
66
Revised 10/98