Easy Replacement Procedure - ASCOM d62 Talker User Manual

User Manual
Ascom d62 DECT Handset

14.2.2 Easy Replacement Procedure

During the Easy Replacement procedure, the LEDs of the handset and the charger follow
the same LED indications. This means that if the old handset has a broken display, the LED
indications on the charger and on the handset can be used to follow the replacement
procedure. Before and after easy replacement, the LEDs may have different LED
indications. For more details, see
IMPORTANT: Never remove a handset from the charger until the instructions in the
1
Figure 13. Easy Replacement via DC4 Advanced Desktop Charger.
1 On the new handset, press and hold
Note: Do not release
2 Put the new handset in the charger.
3 When the text "Start phone replacement?" is displayed, release
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears in
the display. Press "OK"(left soft key).
4, 5 When the text "Please insert old phone in charger" is displayed, replace the new
handset with the old handset. The handset can either be switched on or off.
Note: If the CR3 Rack Charger is used, the same charging slot has to be used for
both handsets.
The handset will be restarted and after a few seconds, the text "Saving settings. Do
not remove phone from charger" appears. The charger LED changes to slow
orange flashing.
2009-12-08/ Ver. C
LED Indications during Easy Replacement
display or the LED tells you to do so (see status on the LED if the display is
broken). If there is an error indication it may be allowed to remove the
handset, see 12 Troubleshooting
After the old handset has been in the charger, the new handset needs to
be placed in the charger regardless if the replacement was successful or
not. Failing to do so may result in malfunction and the new handset will
need to be sent for service.
New
New
2 3
until you are instructed to do so.
on page 65 for further instructions.
New Old
4, 8 7 5 6
TD 92477GB
on page 72.
.
71