ASCOM d62 Talker User Manual page 73

User Manual
Ascom d62 DECT Handset
Could not encrypt
connection
Not allowed
LED Error Indications
See also chapter
LED is flashing red, quick flash, (100 ms on, 800 ms off)
1) If a third handset, that is another handset than the "old" (the replaced handset) and
"new" (the replacement heandset) handset, is inserted into the charger during Easy
Replacement, this error indication appears. Change to the correct handset.
2) The charger has found that Easy Replacement does not work. Change back to the
"new" handset.
LED is flashing red, long flash (800 ms on, 100 ms off)
Error during Easy Replacement. Both telephones need to be sent for service.
2009-12-08/ Ver. C
The parameter "Encryption
Required" is enabled in the
handset in combination with;
1) Unencrypted base station(s);
and/or,
2) Unsupported base station(s).
1) The handset with the shared
phone functionality enabled
cannot be logged in due to
another handset using the
extension (that is, User).
2) The extension (User) does not
exists.
3) The password is not correct.
LED Indications during Easy Replacement
TD 92477GB
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in the
base station(s); and/or,
Note: If Ascom's base
station(s) is used, the software
version must be 3.1.x or
greater.
3) Use supported base
station(s). Ask your supplier.
1) Logout the handset using
the extension.
2) Make sure that you entered
correct extension. If needed,
contact the system
administrator.
3) Make sure that you have
entered correct password. Ask
the system administrator if you
have forgot the password.
on page 72.
67