Installation. Vandal Dome - Digimerge DPV24D Instruction Manual

INSTALLATION. VANDAL DOME

1
2
a
b
3
DPV24TLX ONLY
When using DC power, note the correct polarity stated on the
label attached to the power cord.
1) Remove the three tamper screws using the provided
allen key. Size is standard T-15
Note: If you plan to use conduit fitting, remove conduit
cap using the prodivded conduit key.
Method 1 - Direct Attach Install
2a) Use included mounting template to mark and pre-
drill the required holes. Use 2pc of the 2.8" screws
to mount the camera directly to the mounting
surface.
Remove (one base locking screw, used for shipping
purposes) and install the 3rd 2.8" screw.
Go to step
OR
Method 2 - Camera Base Install
Note: Use this method if installing onto junction box
plate.
2b) Remove the camera base by unscrewing the base
locking screw, and turn camera module approx. 5
degrees counter-clockwise to detach camera base
from the camera module. Now you install the base
to the correct holes as indicated on the mount
template using the 1.2" screws.
Note: If you plan on installing onto a junction
box, attach provided fitting plate first to
a
the junction box and then you attach the
camera base to the fitting plate.
3a) Reinsert camera module into camera base
b
by ligning up the arrow notches, and turning
camera module clockwise to lock into place.
3b) Use the supplied three base locking screws to
secure camera base to camera module.
Go to step
-6-
4
on page 7 to complete installation.
4
on page 7 to complete installation.