52
Operation
4.
Adjust center of detection area with [Near] button or [Far] button in [MOVE X] and [MOVE Y] option.
5.
Select [RETURN] and exit [MOTION DET] menu with [Open] button or [Close] button.
,
Note
•
Even though Motion Detection function is set to [ON], Motion Detection function does not work in
the following cases.
>
When OSD Menu is being configured
>
When Pan/Tilt/Zoom function is working
>
When Pattern or Swing or Auto Pan is working
•
When motion is detected during Preset Tour or Group Tour, waiting time is automatically extended.
When motion is not detected any more, waiting time starts running.
•
When there are alarm inputs, waiting time is not extended even though motion is detected.
Communication
This setting is required to establish a connection between the system controller and the camera.
1.
Select [COMMUNICATION] option on the [SPECIAL] menu.
4
2.
Press [Open] or [Close] button.
3.
Set the below options.
•
Protocol: This item lets you set a protocol for RS-485 communication. Select the desired
protocol.
•
Baud Rate: Select the desired speed of communication between the system controller and the
camera. Confirm selected parameter to the baud rate of the system controller.
•
SAVE & EXIT: Select this option and then press [Open] or [Close] button to save the
communication settings and exit the setting menu.