DFI G7B330-B User Manual page 83

Suspend Mode
When the system enters the Suspend mode, the CPU and onboard
peripherals will be shut off.
HDD Power Down
This is selectable only when the Power Management field is set to
User Define. When the system enters the HDD Power Down mode
according to the power saving time selected, the hard disk drive will
be powered down while all other devices remain active.
Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec. Regardless of whether the Power Management func-
Instant-Off
Wake-Up By PCI Card
Enabled
Disabled
tion is enabled or disabled, if the power button is
pushed and released in less than 4 sec, the system
enters the Suspend mode. The purpose of this func-
tion is to prevent the system from powering off in
case you accidentally "hit" or pushed the power but-
ton. Push and release again in less than 4 sec to
restore. Pushing the power button for more than 4
seconds will power off the system.
Pressing and then releasing the power button at
once will immediately power off your system.
This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the PCI
PME (Power Management Event) signal to remotely
wake up the system.
card will cause the system to wake up.
card's documentation for more information.
The system will not wake up despite access to the PCI
card.
Access to the LAN card or PCI
3
BIOS Setup
Refer to the
83