DFI G7B330-B User Manual page 12

1
Introduction
while USB 2.0 supports 480Mb/second bandwidth providing a
marked improvement in device transfer speeds between your com-
puter and a wide range of simultaneously accessible external Plug
and Play peripherals.
wake-on-ring
wake-up/power-on to respond to calls coming from an external mo-
dem or respond to calls from a modem PCI card that uses the PCI
PME (Power Management Event) signal to remotely wake up the
PC.
wake-on-lan
It is supported via the onboard LAN port or via a PCI LAN card
that uses the PCI PME (Power Management Event) signal. However,
if your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
wake-on-PS/2
system.
12
The system board supports USB 2.0 and USB 1.1
USB
ports. USB 1.1 supports 12Mb/second bandwidth
This feature allows the system that is in the
Suspend mode or Soft Power Off mode to
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
This feature allows the network to remotely
wake up a Soft Power Down (Soft-Off) PC.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
This function allows you to use the PS/2
keyboard or PS/2 mouse to power-on the
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.