DFI G7B330-B User Manual page 50

2
Hardware Installation
Chassis Open Connector
Chassis signal
The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to J1.
Whenever a chassis component has been removed, the sensor
sends signal to J1 alerting you of a chassis intrusion event. To disable
this function, place a jumper cap over J1.
Hardware Monitor for Windows
Install the "Hardware Monitor for Windows" utility. By default, the
chassis intrusion detection function is disabled. When enabled, a
warning message will appear when the chassis is open. The utility can
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the "Hardware Monitor for Windows"
section in chapter 4 for more information.
50
Ground
1
2