Table of Contents
Advertisement
Operating Your Fan and Remote Control (Continued)
Setting the code
CAUTION: Ceiling angle shall not exceed 30 degrees.
Controller Models: FAN28R-240W
Installing receiver
WARNING: To reduce the risk of re or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements.
Electrical source and fan must be 110/120 volt, 60Hz.
Maximum fan motor amps: 1.0
Maximum light watts: 120 incandescent only.
Care and Cleaning
WARNING: Make sure the power is off before cleaning your fan.
Because of the fan's natural movement, some connections may become loose. Check the support connections, brackets, and blade
attachments twice a year. Make sure they are secure. It is not necessary to remove fan from ceiling.
Clean your fan periodically to help maintain its new appearance over the years. Do not use water when cleaning, as this could damage
the motor, or the wood, or possibly cause an electrical shock. Use only a soft brush or lint-free cloth to avoid scratching the nish. The
plating is sealed with a lacquer to minimize discoloration or tarnishing.
You can apply a light coat of furniture polish to the wood for additional protection and enhanced beauty. Cover small scratches with a
light application of shoe polish.
You do not need to oil your fan. The motor has permanently lubricated sealed ball bearings.
A. Wire Connection:
Fan Green Wire...............................................Bare Supply Wire
Red Receiver Wire (AC IN L)............................Black Supply Wire
White Receiver Wire (AC IN N)........................White Supply Wire
White Receiver Wire (TO MOTOR N)................White Fan Wire
Black Receiver WIre (TO MOTOR L).................Black Fan Wire
Blue Receiver Wire (FOR LIGHT)......................Blue Light Wire
NOTE: If other fan wires are a different color, have this unit
installed by a licensed electrician.
B. Lay the brown antenna wire on top of the receiver, and slide the
receiver into the mounting bracket.
Transmitter operation
NOTE:This remote is equipped with 16 code combination. To
prevent possible interference from or to other remote units
such as garage door openers, car alarm or security system,
simply change the combimation code but be sure that the
code on both the hand held transmitter and receiver in the fan
are matched.
Install a 9 volt battery (included).
Operating the fan
Hi Key - High Speed
Low Key - Low Speed
Light/Dimmer Key - Dim the light with memory
l P
a e
e s
o c
t n
3 1
Med Key - Medium Speed
Off Key - Power Off
H
A
M
c a
1 t
8 -
7 7
5 -
7 2
0 -
1 3
f 3
r o
u f
t r
P
O T
N
B
Y A
C .
O
M
e h
a r
s s
s i
a t
c n
. e
Hide quick links:
Advertisement
Table of Contents
