Hanging The Fan - HAMPTON BAY SOUTHWIND 52371 Use And Care Manual

Assembly -Close-To-Ceiling Mounting
Remove canopy ring from the canopy (C) by turning the ring
to the right until it unlocks.
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws on the top of the canopy (C).
Remove the two non-slotted screws and loosen the slotted
screws.
Remove the decorative canopy bottom cover from the
canopy (C) by depressing the three studs.
Remove three of the six screws and lock washers (every
other one) securing the motor collar to the top of the fan
motor housing.
Place the rubber gasket (HH) over the remaining three
screws, route the wires exiting the top of the fan motor
through the canopy ring (make sure the slot opening are on
top), then proceed to place the ceiling canopy (C) over the
collar at the top of the motor.
Align the mounting holes with the holes in the motor and
fasten, using the three screws and lock-washers removed
previously. Tighten the mounting screws securely.
Assembly – Hanging the Fan
4
Attaching the fan to the electrical
box
WARNING: To reduce the risk of re, electric shock, or
other personal injury, mount the fan to an outlet box or
supporting system marked acceptable for fan support and
use the mounting screws provided with the outlet box.
Pass the 120-Volt supply wires through the center hole in
the mounting bracket (A).
Install the ceiling mounting bracket on the outlet box by
sliding the mounting bracket (A) over the two screws
provided with the outlet box. If necessary, use leveling
washers (not included) between the mounting bracket (A)
and the outlet box. Note that the at side of the mounting
bracket (A) is toward the outlet box. When using close-to-
ceiling mounting, it is important that the mounting bracket
be level.
Securely tighten the two mounting screws.
5

Hanging the fan

Carefully lift the fan motor assembly (D) up to the
mounting bracket (A).
Seat the hanger ball portion of the ball/downrod assembly
(B) in the mounting bracket socket. Ensure that the tab on
the mounting bracket (A) socket is properly seated in the
groove in the hanger ball. If using close-to-ceiling
mounting, hang the fan on the hook provided by utilizing
one of the holes at the outer rim of the ceiling canopy.
WARNING: The hook as shown is only to balance fan while
attaching wiring. Failure to hang as shown may result in hook
breaking, causing the fan to fall. Hook must pass from inside
to outside of canopy.
8
C
C
HH
D