7
Using the VP-437xl
The VP-437xl can be controlled via:
•
The front panel buttons (see section 7.1)
•
The OSD menu (see section 7.2)
•
RS-232 serial commands transmitted by a touch screen system, PC, or
other serial controller (see section 7.3)
•
The ETHERNET (see section 7.4)
•
The infrared remote control transmitter (see section 7.5)
7.1 Controlling via the Front Panel Buttons
The VP-437xl includes the following front panel buttons:
•
Input selector buttons for selecting the required input: CV, YC,
COMPONENT (1 and 2), VGA or HDMI (1 and 2)
•
BLANK, MUTE and FREEZE buttons
•
MENU, ENTER, and arrow
•
RESET TO XGA/720p and PANEL LOCK buttons
7.1.1
The Auto Adjust Feature
The auto adjust feature
pressing the ENTER front panel button or the OK button on the remote
control transmitter
You can also implement this feature every time the input is switched to VGA
or when the input resolution changes, via the FINE TUNE menu (
7.2 Using the OSD Menu
The control buttons let you control the VP-437xl via the OSD menu.
Press the:
•
MENU button to enter the menu
•
ENTER button to accept changes and to change the menu settings
1
•
Arrow
buttons to move through the OSD menu, which is displayed on the
video output
On the OSD menu, select EXIT to exit the menu.
1 Up, down, left and right
2 As defined in
Table 1
3 Applies only to the VGA input
4 When not within the OSD menu
5 The default timeout is set to 10 seconds
12
Using the VP-437xl
1
buttons
3
automatically centers the image on the screen when
4
.
5
KRAMER: SIMPLE CREATIVE TECHNOLOGY
2
Table
4).