Glass Replacement - Masport F43-NG Owners & Installation Manual

MAINTENANCE

GLASS REPLACEMENT

Your Masport heater is supplied with high temperature, 5mm
Neoceram silica coated ceramic glass that will withstand the
highest heat that your unit will produce. In the event that you
break your glass, purchase your replacement from an author-
ized Masport dealer only, and follow the step-by-step instruc-
tions for replacement.
Removing Glass:
Note: Wearing gloves will protect your hands while han-
dling glass.
1) Remove the door from the unit and place on a soft surface
to prevent scratching.
2) Pull out the door gasket.
3) Remove the 24 nuts holding the glass retainers in place.
Do not remove the nuts underneath the retainers.
4) Remove the door catch plate.
5) Remove glass retainers on sides first (3 each side) then
remove two center retainers.
Note: Center glass retainers are glued to center glass.
6) Remove glass from aluminium extrusions. When remov-
ing center glass, leave white insulation in place.
Safety Screen:
Only required in
Australia
20
Installing Glass:
1) Install both center and side glass onto aluminium extru-
sions as per diagram.
2) Place glass assembly into door frame.
3) Install retainers by placing 1 drop of glue where previous-
ly glued and put in place.
4) Install side retainers.
5) Install door catch plate.
6) Install the 24 nuts loosly, do not tighten yet.
7) Tighten side panels nuts using the following procedure:
a. tighten top & bottom outside corner nuts (2)
b. tighten inside nuts (3)
c. tighten top & bottom inside corners (2)
8) Tighten the 10 nuts on center glass retainer.
9) Repeat step 7 for other side panel.
10) Replace new gasket by gluing it in place.
11) Install door onto stove and check the seal.
Masport F43/F28 Freestanding Gas Heater