Table of Contents
Advertisement
IMPORTANT
MAINTENANCE INSTRUCTIONS
SERVICE ANNUALLY ONLY BY AN
AUTHORISED PERSON
1)
Clean the burner and control compartment of lint and
house dust by brushing and vacuuming at least once
a year. When cleaning the logs, use a soft clean brush
as the logs are fragile and easily damaged.
During the annual service the burners should be
removed from the burner tray and cleaned. Replace
logs and embers as per instructions on pages 9 and
10.
2)
Clean glass (never when unit is hot), appliance, louvres,
and door with a damp cloth. Never use an abrasive
cleaner. The gold louvres (and optional gold door) may be
scratched if abrasives are used to clean them.
The heater is finished in a heat resistant paint and should
only be refinished with heat resistant paint (not with wall
paint). Regency uses StoveBright Paint - Metallic Black
#6309.
3)
Make a periodic check of burner for proper position and
condition. Visually check the flame of the burner period-
ically, making sure the flames are steady; not lifting or
floating. If there is a problem, call an authorized service
person or your local dealer.
4)
The appliance and flueing system must be inspected
before use, and at least annually, ONLY by an authorised
field service person, to ensure that the flow of combustion
and ventilation air is not obstructed.
During the annual service call, the burners should be
removed from the burner tray and cleaned. Replace the
embers - do not block the pilot or burner ports.
5)
Keep the area near the appliance clear and free from
combustible materials, gasoline, aerosols, and other
flammable vapours and liquids.
WARNING:
CHILDREN AND ADULTS SHOULD BE
ALERTED TO THE HAZARDS OF HIGH SURFACE TEM-
PERATURE AND SHOULD STAY AWAY TO AVOID
BURNS OR CLOTHING IGNITION. YOUNG CHILDREN
SHOULD BE CAREFULLY SUPERVISED WHEN THEY
ARE IN THE SAME ROOM AS THE APPLIANCE.
CAUTION:
ANY SAFETY SCREEN OR GUARD RE-
MOVED FOR SERVICING AN APPLIANCE MUST BE
REPLACED PRIOR TO OPERATING THE
APPLIANCE.
CLOTHING OR OTHER FLAMMABLE MATERIAL
SHOULD NOT BE PLACED ON OR NEAR THE APPLI-
Masport F43/F28 Freestanding Gas Heater
ANCE.
DO NOT USE THIS APPLIANCE IF ANY PART HAS
DO NOT USE THIS APPLIANCE IF ANY PART HAS
DO NOT USE THIS APPLIANCE IF ANY PART HAS
DO NOT USE THIS APPLIANCE IF ANY PART HAS
DO NOT USE THIS APPLIANCE IF ANY PART HAS
BEEN UNDER WATER. IMMEDIATELY CALL A AU-
BEEN UNDER WATER. IMMEDIATELY CALL A AU-
BEEN UNDER WATER. IMMEDIATELY CALL A AU-
BEEN UNDER WATER. IMMEDIATELY CALL A AU-
BEEN UNDER WATER. IMMEDIATELY CALL A AU-
THORIZED SERVICE TECHNICIAN TO INSPECT THE
THORIZED SERVICE TECHNICIAN TO INSPECT THE
THORIZED SERVICE TECHNICIAN TO INSPECT THE
THORIZED SERVICE TECHNICIAN TO INSPECT THE
THORIZED SERVICE TECHNICIAN TO INSPECT THE
APPLIANCE AND TO REPLACE ANY PART OF CON-
APPLIANCE AND TO REPLACE ANY PART OF CON-
APPLIANCE AND TO REPLACE ANY PART OF CON-
APPLIANCE AND TO REPLACE ANY PART OF CON-
APPLIANCE AND TO REPLACE ANY PART OF CON-
TROL SYSTEM AND ANY GAS CONTROL WHICH HAS
TROL SYSTEM AND ANY GAS CONTROL WHICH HAS
TROL SYSTEM AND ANY GAS CONTROL WHICH HAS
TROL SYSTEM AND ANY GAS CONTROL WHICH HAS
TROL SYSTEM AND ANY GAS CONTROL WHICH HAS
LOG REPLACEMENT
BEEN UNDER WATER.
BEEN UNDER WATER.
BEEN UNDER WATER.
BEEN UNDER WATER.
BEEN UNDER WATER.
The unit should never be used with broken logs. Turn off the
gas valve and allow the unit to cool before opening door to
carefully remove the logs. The pilot light generates enough
heat to burn someone. If for any reason a log should need
replacement, you must use the proper replacement log. The
position of these logs must be as shown in the diagram under
Log Installation.
Note: Improper positioning of logs may create carbon
build-up and will alter the unit's performance which
is not covered under warranty.
DOOR AND GLASS GASKET
If the door gasket requires replacement use 7/8" diameter oval
door gasket. The glass requires 5/8" flat glass gasket. See
your Masport dealer.
GOLD-PLATED DOORS
The 24 carat gold plated finish on the door requires little
maintenance, and need only be cleaned with a damp cloth.
DO NOT use abrasive materials or chemical cleaners, as they
may harm the finish and will void the warranty. Clean any
fingerprints off before turning the unit on.
MAINTENANCE
19
Hide quick links:
Advertisement
Table of Contents
