Door Installation And Door Latch; Front Door Installation - Masport F43-NG Owners & Installation Manual

FRONT DOOR INSTALLATION

1) Open the two side panels.
2) Slide the door onto the two hinge pins making sure the two
pieces are flush together. See diagram 1.
3) Close the door. The latch plate must be centered around
the alignment pin. See diagram 2. If the latch plate
interferes with the corner of the stove you may want to
angle the plate slightly so the door closes easier.
Masport F43/F28 Freestanding Gas Heater
Diagram 1
Diagram 2 - F28
Diagram 2 - F43
4) The latches should already be at the proper setting. If they
are too hard or too easy to close, you may want to adjust
them by loosening the latch catch. See diagram 3.
5) Remove the blue plastic protective coating from the
glass.
6) Test the seal around the door by placing a piece of paper
between the unit and the door, close the door and try to
pull the paper out. If it slips out easily, then the door is not
properly sealed. Tighten or loosen the latch. See diagram
3.
Note: The door latch may require adjustment as the door
gasket material compresses after a few fires and
after glass replacement. Turn the latch catch in-
ward or outward to loosen or tighten.
Diagram 3 - F28
Diagram 3 - F43
INSTALLATION
11