Glass Installation; Blower/Fan; Wiring Diagram - Masport F2101 Owners & Installation Manual

Hide thumbs

Table Of Contents

Table of Contents

Your Masport stove is supplied with 5 mm Neoceram ceramic glass that will withstand the

highest heat that your unit will produce. In the event that you break your glass by impact,

purchase your replacement from an authorized Masport dealer only.

Remove the door from the stove and remove the glass retainer. Position the glass in the

door, make sure that the glass gasketing will properly seal your unit, and replace the

retainer, it should rest on the gasket not the glass. Tighten securely, but do not wrench down

on the glass as this may cause the glass to break.

The blower/fan can be purchased and installed during the initial instal-

lation or added on later.

1) Remove the two screws from the top of the fan housing.

2) Slide the fan up into the rear heat shield.

3) After aligning holes, secure the fan to the rear heat shield using the

two screws removed earlier.

Note: The connection cord should not be in contact

with any hot surfaces.

Read the operating instructions for the fan before using. See Page 16.

WARNING: Electrical Grounding Instructions

This appliance is equipped with a three pronged (grounding)

plug for your protection against shock hazard and should be

plugged directly into a properly grounded three-prong recep-

tacle. Do not cut or remove the grounding prong from this

plug.

Masport Freestanding Woodstove