Table of Contents
Advertisement
English Manual
2. Installation
The installation of the Extender C5 set is straightforward and can best be achieved in most cases by
following these stages for each module:
Check or set the configuration switch settings
•
Mount the module
•
Connect the cables
•
2.1 Configuration switch settings
The basic operations of the LOCAL and REMOTE modules are controlled by the banks of four switches located
on the side of each module. The switches are monitored at all times and may be changed when power is on or
off (the only exception to this rule is switch 1 of the LOCAL module which initiates slightly different functions
depending on the power state when it is switched).
LOCAL Switch 1
OFF:
Normal operation
ON:
(Before power is applied) Places the LOCAL module into flash upgrade mode so that the internal
software can be changed. (See section 6. Flash upgrade procedure)
ON:
(Whilst power is applied) Places the REMOTE module into password override mode. This allows any
pre-configured passwords to be altered – particularly useful when they have been lost or forgotten. (See
section 5.5 Password override.)
Note: When shipped, all switches are set in the OFF positions and this will produce normal operation with
normal microphone input (at the REMOTE module.)
LINDY KVM Extender C5 Pro
Installation and Use
page 9
Advertisement
Table of Contents
