Installation - Lindy 39245 User Manual

User Manual

Installation

Transmitter
LINK LEDs: Green LED illuminates when the unit is powered on; Blue LED illuminates when the
•
connection with the receiver is established.
CHANNEL: See Rotary Switch function below in Operation paragraph.
•
SETTING: See Transmitter's Switch/Button table below in Operation paragraph.
•
• EDID: Copy EDID button.
RS232: Connect to a PC or serial device using the supplied 3.5mm to RS-232 cable.
•
LINE OUT: Connect a microphone to pass-through analogue audio input from the receiver.
•
LINE IN: Connect to a source with a 3.5mm stereo audio cable to pass-through analogue audio.
•
USB HOST: Connect to a PC using the supplied USB Type A / B cable.
•
RJ45: Connect the receiver unit using a single Cat.6 or above cable for all data signals.
•
o LINK LED: Illuminates when the connection with the receiver is established.
o ACT LED: Illuminates when data is transferred.
DVI IN: Connect to a DVI source device using a DVI cable (not included).
•
• DVI LOOPOUT: Connect to a DVI display for local monitoring.
DC 5V: Connect the supplied PSU.
•
Receiver
LINK LEDs: Green LED illuminates when the unit is powered on; Blue LED illuminates when the
•
connection with the transmitter is established.
CHANNEL: See Rotary Switch function below in Operation paragraph.
•
SETTING: See Receiver's Switch/Button table below in Operation paragraph.
•
MENU: See Receiver's Switch/Button table below in Operation paragraph.
•
• SELECT: See Receiver's Switch/Button table below in Operation paragraph.
USB: 4 USB 2.0 Ports to connect USB devices such as mice, keyboards, mass storage and hard
•
drives (web cams are not supported)
RJ45: Connect the transmitter unit using a single Cat.6 or above cable for all data signals.
•
o LINK LED: Illuminates when the connection with the transmitter is established.
o ACT LED: Illuminates when data is transferred.
DVI OUT: Connect to a DVI display using a DVI cable (not included).
•
LINE OUT: Connect to an analogue 3.5mm amplifier, speakers or headphones.
•
MIC IN: Connect to an analogue 3.5mm device to pass-through a microphone input from the
•
transmitter (mono analog audio input only).
• RS232: Connect to a PC or serial device using the supplied 3.5mm to RS-232 cable.
• DC 5V: Connect the supplied PSU.
English