Installation - Lindy 38398 User Manual

User Manual English

Installation

Transmitter
HDMI OUT: Connect to a local HDMI display.
HDMI IN: Connect to an HDMI source device.
RESET: Press and hold the button for 3 seconds to reset the unit (EDID will restore to default status:
1920x1080@60Hz).
CAT OUT: Connect the CAT IN port on the Transmitter or to a network switch with a Cat.x cable.
IR OUT: Connect the supplied IR Emitter cable for IR signal transmission. Place the IR Emitter in direct
line-of-sight of the equipment to be controlled.
LINK LED: The LED will flash blue when the Transmitter is connected directly to a Receiver or through a
network switch.
POWER LED: The LED will illuminate blue when the Transmitter is powered on.
DC 5V: Connect the 5VDC 1A PSU to an AC wall outlet.
Receiver
HDMI OUT: Connect to an HDMI display.
RESET: Press and hold the button for 3 seconds to reset the unit to factory defaults, short press the button
to copy the EDID from the connected display to Transmitter's HDMI source device.
CAT IN: Connect the CAT OUT port on the Transmitter or to a network switch with a Cat.x cable.
IR IN: Connect the supplier IR Receiver cable for IR signal reception. Ensure the remote being used is
within the direct line-of-sight of the IR Extender.
LINK LED: The LED will flash blue when the Receiver is connected directly to a Transmitter or through a
network switch.
POWER LED: The LED will illuminate blue when the Receiver is powered on.
DC 5V: Connect the 5VDC 1A PSU to an AC wall outlet.