Advertisement
User Manual
Installation
Please follow the below instructions for installation.
Lindy advises using high-quality HDMI cables up to 3m in length on the input, and 3m in length on the
output. Cat.5e cabling can also be used however this will impact the maximum distance possible, therefore
Cat.6 cable or above is recommended for use. Please ensure all devices are switched off prior to
installation.
1. Connect an HDMI display to the required receiver unit using HDMI cable.
2. Connect a Cat.6 or above network cable to the Cat In port of the receiver unit.
3. Connect the opposing end of the Cat.6 cable to one of the 4 Cat Out ports of the matrix.
4. For local HDMI distribution, connect up to 4 HDMI displays to the local HDMI Out ports of the matrix
unit.
5. Connect up to 4 HDMI source devices to the HDMI In of the matrix unit.
6. Connect the multi-country power supply to the DC jack of the matrix unit and plug into a mains
socket.
7. Switch on all devices. The Power LED of the matrix and receiver units will illuminate once power
has been supplied. Power is provided to the receivers over the network cable using PoC.
8. For additional infrared remote signal functionality, connect the included IR Extension Cables to the
matrix and receiver units, using the IR emitter cable with the IR Out port on the matrix and the IR
receiver with the IR in port of the receivers. Please ensure the emitter cable is in front of the IR port
that will be controlled, while the IR receivers are in line of sight of the IR remote.
Control
The matrix includes various methods of control above the push buttons on the main unit for simple content
distribution, or for integrating into control systems.
IR Control
The unit supports one-way IR matrix function. When the matrix is connected to a receiver via a Cat.6
cable, you can control the input source device (local end) by the IR control signal from the receiver
(remote end). IR signal follows video switch to change. For example, the HDMI output signal on the
receiver 1 comes from the HDMI IN 1 port, so IR input signal of the receiver 1 will emit to IR OUT 1 port
of the Matrix. The HDMI output signal on the receiver 3 comes from the HDMI IN 2 port. Then, IR input
signal of the receiver 3 will emit to IR OUT 2 port of the Matrix and so on. The IR OUT signal of the
Matrix depends on the IR remote of source device.
It's also possible to assign ports following the steps below:
1. Power on the matrix or put the matrix into standby mode.
2. Output 1: Press 1, 2, 3 or 4 to assign the HDMI Input to HDMI Output 1.
3. Output 2: Press 1, 2, 3 or 4 to assign the HDMI Input to HDMI Output 2.
4. Output 3: Press 1, 2, 3 or 4 to assign the HDMI Input to HDMI Output 3.
5. Output 4: Press 1, 2, 3 or 4 to assign the HDMI Input to HDMI Output 4.
6. < >: Select the previous or next HDMI Input.
English
Advertisement
