Advertisement
Introduction
Thank you for purchasing the LINDY USB 2.0 Cat.5 Extender for 2 PCs. This extender is
composed of a transmitting unit with 3 USB ports and a receiving unit with 7 USB ports and
enables two USB host devices to send data up to 100 metres.
Package Contents
• Local/Transmitter Unit
• Receiver Unit
• Multi-Country Power Supply 5V DC 2A for local unit
• Multi-Country Power Supply 5V DC 3.5A for receiver unit
• 2 USB Cables
• Four assembly brackets
• LINDY Manual
Features
• True plug and play, no driver installation required
• This USB 2.0 Cat.5 Extender can be shared by two PCs
• Local unit with 3 Port USB 2.0 hub, remote unit with 7 port USB 2.0 hub
• Extends USB 2.0 high-speed and USB 1.1 (low-speed, full-speed) devices up to 100m
over Cat 5e (or better) cable.
• Supports all USB device types: Control, Interrupt, Bulk and Isochronous at up to
480Mbps
• Supports all major operating systems with USB support
• Switching between computers by push button
Installation
1.
Place the local extender near the computer(s). Install the supplied USB cable between the
local extender and USB port on the host computer(s).
to connect the local extender unit to the host computer.
2.
Connect the supplied 5VDC 2A power adapter to the local unit.
3.
Place the remote extender near the USB device(s) in the desired remote location.
4.
Connect the supplied 5VDC 3.5A power adapter to the remote unit.
5.
Connect the local to the remote extender by using a Cat.5 (or better) cable (not
included!).
To switch between the two PCs, please push the button on the transmitter and wait about 5
seconds.
LED indications
• Power LED on transmitter: power supply is on; on receiver: lights only when PC is on
• Active: USB device is connected
• Link: transmitter and receiver are connected by Cat.5 (or higher) cable
• USB ports on transmitter/receiver: respective LED lights when device is connected
• PC1/PC2: shows which PC is active
USB Type B connectors are used
[1]
Advertisement
