Screwdriver - Teeter Hang Ups ComforTrak Series Assembly Instructions Manual

FIGURE 1
FIGURE 2
FIGURE 3
Right
1
2
1
Spreader Arms
2
Crossbar
Assemble the front Stability Feet (F7-1033) onto the A-Frame (E6-1100)
Feet may come pre-assembled.
• Lay the A-Frame on the floor with the Crossbar on the top side (Figure 1) to assemble
the front Stability Feet.
• Select the Stability Foot labeled Number 1 on the inside and place it on the RIGHT side of
the A-Frame. Insert two of the Screws (E1-1002), one through the side and one through the
bottom (Figure 2). Tighten using the Screwdriver (F5-1130) provided.
• Repeat with the Stability Foot labeled Number 2 on the LEFT side (Figure 2).
• Position the A-Frame on its feet and open it so the Spreader Arms are locked (Figure 3).
• Familiarize yourself with the Front, Back, Left and Right of the A-Frame. You may want to
refer back to this diagram for reference throughout the assembly process.
Left
Step 1